Cold Plunge Site and Installation Readiness Checklist
=====================================================
A pre-delivery checklist covering structure, power, drainage, access, climate, and daily convenience so a premium cold plunge lands in the right spot the first time.

[ ] Calculate the filled weight: water volume in gallons times roughly eight pounds, plus the shell, chiller, and a bather, and confirm the floor, deck, or slab can carry that load on the unit's footprint.
[ ] For any deck, balcony, rooftop, or upper floor, obtain a written structural assessment before scheduling delivery rather than after.
[ ] Choose a level, well-drained base such as a concrete pad, pavers on a compacted bed, or a reinforced deck section, and check it with a long level.
[ ] Measure the full delivery path against the crated dimensions: driveway, gates, side yards, doorways, stair turns, elevator cabs, and overhead clearances.
[ ] Confirm in writing who moves the unit from the curb to its final position, and whether that requires a crew, a dolly, or lifting equipment you must arrange.
[ ] Read the electrical requirement on the spec sheet: voltage, amperage, plug type, and whether the manufacturer calls for a dedicated circuit.
[ ] Have a licensed electrician install a GFCI-protected outlet or hardwired connection at the distance from the water required by your local code.
[ ] Verify the airflow clearance the chiller needs on each side and above, and keep that space free of walls, planters, and storage.
[ ] Decide where the chiller's warm exhaust air will go, especially in a garage, basement, or enclosed patio where it can raise the room temperature.
[ ] Identify a drain path or a hose route for full water changes, and check that the discharge point can take the volume without flooding a neighbor or a lawn.
[ ] Confirm a hose bib or water supply close enough for filling and regular top-ups without dragging a hose through the house.
[ ] Assess sun exposure at different times of day; shade reduces chiller runtime, slows algae, and protects the shell finish from UV fading.
[ ] Consider compressor noise relative to bedrooms, a home office, and property lines, and ask the seller for a demonstration or a published sound rating.
[ ] For indoor placement, plan for splash, condensation, and humidity with a wet-rated floor, a floor drain if possible, and adequate ventilation.
[ ] In cold climates, confirm the unit's freeze protection features or write a winterization plan for the plumbing and chiller.
[ ] In hot climates, confirm the chiller is rated for the ambient temperatures your site actually reaches in summer, not just the room-temperature spec.
[ ] Plan the entry and exit: sturdy steps or a platform, non-slip surfaces, and a place to stand while dripping that will not become an ice patch in winter.
[ ] Check Wi-Fi signal strength at the exact spot if the unit relies on an app for scheduling, monitoring, or alerts.
[ ] Review HOA rules, local permit requirements, and your homeowner's insurance for anything that applies to a filled tub on the property.
[ ] Read the warranty terms for installation conditions, such as professional electrical work or a level base, that could void coverage if skipped.
[ ] Set up the small conveniences within reach: towel hook, mat, timer or clock, thermometer, and a spot to rest the lid where it will not get damaged.
[ ] Schedule delivery for a time when you or a trusted person can inspect the shell, lid, and chiller housing for shipping damage before signing.
[ ] Photograph the site and the unit on delivery day so you have a dated record for any warranty or damage claim.